Chat with us, powered by LiveChat NegotitionsAnswers 1Homework Help - BonPapers

NegotitionsAnswers 1Homework Help

5.
 
 
 

A company has just negotiated a contract to produce a part for another firm. In the process of manufacturing the part, the inside diameter of successive parts becomes smaller and smaller as the cutting tool wears. However, the specs are so wide relative to machine capabilities that it is possible to set the diameter initially at a large value and let the process run for a while before replacing the cutting tool.

       The inside diameter decreases at an average rate of .001 cm per part, and the process has a standard deviation of .05 cm. The variability is approximately normal. Assuming a three-sigma buffer at each end, how frequently must the tool be replaced if the process specs are 3 cm and 3.5 cm. Use (Number of shafts)n = 1. 

Picture

 

Determine how many pieces can be produced before the LCL just crosses the lower tolerance of  3 cm. (Do not round your intermediate calculations.)

 

  After [removed] pieces the cutting tool should be replaced.

Order an Excellent Paper with Bonpapers.com Writing Service

Bonpaper is a Custom Research Paper Writing service based in USA that is Available 24/7 to cater your needs. We have huge experience of writing essays about every possible topic. We have access to the online libraries, peer-journals, and news sites which makes it possible to gather enough data about the topic. 

We provide the plagiarism-free and grammatically perfect essay writing service to our clients. We have written hundreds of essays so far and our clients have gained excellent results as well.

Need Assignment Help?